User manual
ADT-TP3340DJ Three-axis Dispenser
- 10 -
start speed”.
Space shift speed: The fast positioning speed of motor during processing is called as space
shift speed. 0% corresponds to the “Minimum speed” of the axis, while 100% corresponds to the
“Maximum speed”.
Space shift acceleration: The higher the space shift acceleration is, the shorter the time
from “Space shift start speed” accelerated to “Space shift speed” and the time from “Space shift
speed” decelerated to stop are; otherwise, the longer the time is. 0% corresponds to the
“Minimum acceleration” of the axis, while 100% corresponds to the “Maximum acceleration”.
2) Stopping position
This is the position that the motor stops when the processing file running completes. If
certain axis has stopping position, the motor automatically runs to the specified position and then
stops when the processing file running completes.
3) Delay setting
Gun replacing time: When several glue guns are used, if it is necessary to replace the glue
gun (specify another glue gun in next processing file), this parameter is used to set the time
required to replace glue gun.
Automatic dispensing time: The automatic dispensing function is to turn on the glue gun
regularly to make the colloid flow and prevent concretion when the motor is in stopping state. The
“Automatic dispensing time” is the time duration when the glue gun is turned on every time.
Automatic dispensing interval: The automatic dispensing function is to turn on the glue
gun regularly to make the colloid flow and prevent concretion when the motor is in stopping state.
The “Automatic dispensing interval” is the time interval when the glue gun is turned on every
time.
* Gun feeding in-place time: This parameter is available when the “Gun feeding mode” is
set to “Cylinder”. The time from the gun feeding/retreating cylinder receives gun feeding signal to
arriving gun feeding point is the gun feeding in-place time. The machine won’t perform next
action before the delay.
* Gun retreating in-place time: This parameter is available when the “Gun feeding mode”
is set to “Cylinder”. The time from the gun feeding/retreating cylinder receives gun retreating
signal to arriving gun retreating point is the gun retreating in-place time. The machine won’t
perform next action before the delay.
Note: If the external gun feeding/retreating signals of the feeding/retreating cylinder are
available, the machine will perform next action even if the delay time isn’t arrived.
Special usage: If the gun feeding or retreating delay is set to 0, it indicates that no delay is
applied and the machine will perform next action only when the external gun feeding/retreating
in-place signals are effective.
4) PLT conversion ratio
PLT is a vector graphics file format, which can describe the graphic characteristics of plane
figure. This file format can be generated with CorelDRAW or AutoCAD. The coordinate units in
PLT file may be different from those in actual graphs. They have a proportion relationship.
Before converting the PLT file to processing file, it is necessary to set this parameter in order to
get the processing file in proper size. PLT file conversion proportion should be set when the pulse
equivalent of every axis has been set properly. You can set in the following method: Draw a
100×100mm square in the computer, generate PLT file and send to the controller, set the PLT
conversion proportion to 1 and convert the PLT file to processing file, enter the editing interface
to view the coordinates difference between two adjacent points, set the difference to L and proper
PLT conversion proportion to K, and the K value can be calculated in this formula: K = 100÷L.
5) Corresponding relationship between gun and pen
In PLT files, different colors (or layers) correspond to different pen numbers. With this
function, you can realize the multi-gun dispensing function. You need to set the pen number
corresponding to every glue gun first, for example, if black corresponds to pen number 1, set the
pen number corresponding to first glue gun to 1, and thus the first glue gun corresponds to black.
The graphs drawn in black will be processed by first glue gun.
Stop position setting (press to select)
Instruction
Instruction
OK
Cancel
X-axis
Y- ax is
Z-axis