User`s manual

XT20100820 HC8200 Flame Cutting Machine User’s Manual
4-7
Parameter definitions of the codes X, Y, I, J, -
X – Displacement of the X coordinate of the end point related to the starting point of the current arc
segment, unit: mm;
Y – Displacement of the Y coordinate of the end point related to the starting point of the current arc
segment, unit: mm;
I – Displacement of the X coordinate of the circle center related to the starting point of the current arc
segment, unit: mm;
J – Displacement of the Y coordinate of the circle center related to the starting point of the current arc
segment, unit: mm;
Parameter definitions of the codes X, Y, I, J , +
X – Displacement of the X coordinate of the end point related to the starting point of the current arc
segment, unit: mm;
Y – Displacement of the Y coordinate of the end point related to the starting point of the current arc
segment, unit: mm;
I – Displacement of the X coordinate of the circle center related to the starting point of the current arc
segment, unit: mm;
J – Displacement of the Y coordinate of the circle center related to the starting point of the current arc
segment, unit: mm;
+ – Refers to the anticlockwise circle.
Attentions to EIS codes
Programming must be 29, 38 (slotting compensation) and 63 (program) ending command.
3 and 4 (explanation) may be ignored, but cannot be used individually.
5 and 6 must be used in pairs
7 and 8 must be used in pairs
Is and Js cannot be ignored
X, Y, I, J, and - cannot be ignored
X, Y, I, J and + cannot be ignored