User`s manual

Chapter 4 Instruction System
4-4
4.3 G command instruction
4.3.1 G92 Reference point setting
While setting running program, the coordinate value of the starting point of the processing must be plated at
the beginning of the program.
Format: G92 X0 Y0
If G92 is not followed by X and Y, then take the coordinates of the current X and Y as the reference point.
Generally speaking, G92 is not followed by X and Y when using machine tool origin positioning.
4.3.2 G00 Idle replacement motion
This command realizes moving to the specified position in a rapid way. While displacement, the system
moves at a straight line from the starting point to the end point at the max. manual speed limit. When G00 is
moving, it is not influenced by the speed ratio.
Format: G00 Xn Yn
For example: G92 X0 Y0
G00 X75 Y75
M02
● Current cutting torch position.
○ Expected cutting torch position.
Figure 4.3.2.1 Idle displacement motion
4.3.3 G01 Straight line cutting
This command allows the cutting torch to move to the specified position in straight line. As a cutting and