User`s manual

Chapter 3 Function and Operation
3-54
of the trail, the following message will display if you press START:
Figure 3.3.1.3 Continue cutting after pause
Press↑ and↓ to move the cursor to the interface you want, as shown in the figure, “Idle return and cut”
means to return to the cutting trail automatically and then start perforating and cutting at the position of the trail;
“Directly cut and return” means to perforate at the current position and then start cutting; “Idle return and stop”
means the torch stops after idle returning to component trail without going to next action; “Continue at current
position” means to cut the next Shape at the track position removed, but the reference point has been changed.
3.4 Manual processing
Under the main interface, press F11 and the system enters manual running mode, as shown in the figure
below: