User`s manual

Chapter 3 Function and Operation
3-52
Select perforation point, number of the perforation point you want to move backward to, and number of the
perforation point you want to move forward to, and select the number of the perforation point according to the
S/N, as shown in the figure below:
Figure 3.3.1.2 Move perforation point interface
The above figure shows how to select number of the perforation point. You can select in three different ways,
“S/N”, “Forward” and “Backward”. After entering the data, press Enter and the cutting torch will move to the
corresponding ignition point, then press START to continue cutting.
Note: if the selected ignition point is not found, the system will prompt you and remain still.
View sheet
To switch component display between plate size and component size.
Common set
Enter system setting interface. Refer to relevant paragraphs above for details.
Consumable
Enter Replace wearing parts interface. Refer to relevant paragraphs above for details.