User`s manual

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-51
3.3.1 Pause
If you need to pause the cutting process, press STOP and the process will be paused, as shown in the figure below:
Figure 3.3.1.1 Pause interface
After pausing the process, you can perform some operations by pressing the following function keys:
Return To Start
To press this key, the cutting torch will return to starting point directly, namely the origin of the relative
coordinates.
Backup
Press and hold F2, the cutting torch will come back along the processing path until the starting point. If F2 is
released in the process, the torch will stop moving.
Forward
Press and hold F3, the cutting torch will go forward along the processing path until the end point. If F3 is
released in the process, the torch will stop moving.
Move To Pierce