User`s manual

Chapter 3 Function and Operation
3-48
3.2.6 F6 Cut mode
Press F6 under the main interface to switch among different cut modes until the one you require. Now the
system supports preview, oxygen gas, plasma, powder spray marking and plasma marking. As shown in figure
3.2.6.1, the cutting mode is displayed in the red circle marked in the interface.
Figure 3.2.6.1 Oxygen gas cut mode
Press F6 under this interface, the cutting mode switches to Oxygen gas from Preview, and the IO monitoring
will change accordingly, as shown in Figure 3.2.6.1.