User`s manual

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-39
Figure 3.2.4.3.7 System setting
1. Filename extension. The system supports TXT, NC, GCD, ESI and ESA files, mainly are G code and
ESI code files.
2. Cut equipment installed. The system provides four kinds of cutting craftsmanship including oxygen gas,
plasma, powder spray marking and plasma marking. You can select the craftsmanship according to what
craftsmanship is installed in your equipment.
3. Alarm prompt options. The alarm prompt options provides the following prompts including Ready to
cut, Slotting too large, Value modified, Component larger than plate, Component modified, and Save component
for recovery. Users can select the prompts according to their actual needs.
4. Whether Open wireless Handwheel Box:if select “Yes”,you can use the wireless Handwheel Box.
The system setting interface also provides data backup and recovery functions:
1. Press F1 to backup the setting value in the current interface.
2. Press F2 to restore the setting value in the current interface to the previous backup.
3. Restore default setting.
Press F8 to save the data after modification.
Password set
Password modifying setting, see Figure 3.2.4.3.8 for the interface.