User`s manual

Chapter 3 Function and Operation
3-32
10. Retract time. The time for retraction after stop.
11. Arc strike retry on fail The consecutive times of arc striking when arc striking feedback signal is valid.
12. Arc strike time. The time from generation of arc starting signal to completion of art striking.
13．Advanced arc OFF dist.: the distance of advancement when advanced arc blowout is required.
14. Use arc feedback signal. Whether or not the feedback is invalid after arc striking.
15. Ignition. Whether or not the ignition signal can be used as arc striking signal during arc striking.
16. Partial Raise. When no height adjuster is applied, whether or not the local rising is valid.
17. Initial position. When no height adjuster is applied, select whether or not to use this initial positioning
function. If it is needed, then a positioning arriving signal is required.
18. Use arc voltage THC. Select Yes when an arc voltage torch height adjuster is connected.
To set the parameters on the right, press F2 and then press Tab to switch among different parameters and
move the cursor to the parameter you want to modify. After setting, save the modified parameter.
Spraying
Figure 3.2.4.2.3 Power spray marking parameters
1. Ignition time. The ignition time delay before powder mixing when flame cutting control is not used in
spray marking process.
2. Dust mix time: The time for mixing the powder after ignition when flame cutting control is not used in