User`s manual

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-25
processed and the steel plate are as follow:
Figure 3.2.3.3.5 Result of right inclination align with X axis as the reference axis
Steel plate aligns method 2: the align reference edge is Y axis.
The principle of this method is the same with method 1, only the reference axis is different. Sometimes the
steel plate on X axis is too short, in this case we can select to calibrate based on Y axis. Before align, select the
base axis and direction of the align and then start calibrating. Set the starting point and end point according to
method 1.
Steel plate align method 3: input align angle directly
As shown in the figure below:
Figure 3.2.3.3.6 Input align angle
3.2.3.4 View sheet
To switch between overall shape display area and single part.