User`s manual

Chapter 3 Function and Operation
3-22
Resorting type
To select resorting type between straight resorting and stagger resorting.
Number of copies
To specify the lines and rows.
Offset
To specify the offset between the resorted components or component complexes.
Waste edge value
To specify the waste width between components; the waste edge values of X axis and Y axis are the same.
3.2.3.3 Sheet Align
This function allows you to calibrate the relative positions of the shape and the steel plate in order to
maintain a reasonable position of the two. The align n interface is shown in the figure below:
Figure 3.2.3.3.1 Plate Align
The principle of Align: