User`s manual

Chapter 3 Function and Operation
3-16
files and Display files of specified format in the right. Press F8 to OK Press ESC to exit.
Delete file
To delete the selected file.
POP U-disk
Remove the inserted U-disk in a safe way to protect the U-disk.
Resume Part
To resume the part under break point memory or power failure protection, e.g. the user pauses the process
and saves the part during the cutting and start cutting another part, you can press this key to recover the saved part;
or in case of power failure during the cutting, if a UPS is provided, the system will save the part automatically
after receiving power alarm, and when power supply resumes, you can press this key to recover the component
before power failure. Note: the break point file is saved according to time. See the figure below:
Figure 3.2.2.4 Break point recovery
When a break point file is selected, press F8 to return to Pause cutting interface.
Show All Files
When the files in the folders are not all displayed, press this key and all files in this folder will be displayed,
and press it again to display the specified files only.
OK (Confirm and return)