User`s manual

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-11
Convert DXF
You can add DXF parts in nesting plan. As the DXF file is conditional, you need to set it manually and so a mouse
is required.
Add part
You can press this key to add part into the nesting plan. The required shapes can be obtained from the shape
library, U-disk or local disk.
Remove part
To remove the selected part from the nesting plan.
Cut earlier
To adjust part cutting order ahead.
Cut later
To adjust part cutting order behind.
View sheet
To switch between all nesting parts and ingle part display; when displaying a single part, all nesting parts are
displayed in the display area.
Setups
Set relevant parameters of the Shape nesting.
OK
Stop nesting and return to main interface, and take the result of nesting as the cutting program.
The left window is the nesting display area, the right up window is part selecting area and the right down
window is part editing area. Modifications to the part will be displayed in the nesting display area in real time.
Press Tab to switch among the three areas. The area currently activated will be highlighted by a blue frame, in
such case the parts selected can be moved by pressing the arrow keys.
Figure 3.2.1.3.3 Moving Shape manually
Convert DXF