User`s manual

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-7
Figure 3.2.1.1.2 Shape
This shape can be seemed as composed of a half rectangle, an isosceles trapezoid, an arc and a circle. User
may also set the parameters to get a different processing shape. If the hole is not required, the radius of the circle
can be set as zero; if the rectangle is not required, the height of the rectangle can be set as zero. The radius of the
arc at the top must be larger than the radius of the circle. After setting the parameters, press the function key F3 to
preview or Tab to preview automatically. If the parameters are not correct, the system will prompt error, otherwise,
press the function key F8 to confirm processing the shape, then the processing file will be saved in PC and the
system enters Auto interface automatically, under which users may use this processing file directly. If ESC is
pressed, the processing file in the system will remain unchanged and the setting is not applied. Under this
interface, press the function key F1 to enter part options interface, under which users can perform the operations
such as rotate array, rotate, zoom-in and mirror. Press F2 to view the code of the component, in such case the
default file is the current file, and you can edit or preview the Shape of this file.
Perforation cutting
As for some simple shapes such as rectangles and triangles, you will find an additional option in the interface
named “Part type”, with two parts cutting types optional: Perforation and Section. You can cut a rectangular hole
(perforating inside the rectangle), or cut a rectangular section (perforating outside the rectangle). Press Tab to
switch to “Part type” option, and press↑or↓to switch between two types. After the Shape is modified, you can