User`s manual

Chapter 3 Function and Operation
3-2
3 Chapter III Functions and Operations
3.1 Introduction
This two-axis controller system can be used to cut an objective according to the Shapes stored in the Shape
library. It is mainly applied in cutting industry. The system enables a convenient operation with many built-in
frequently used Shape.
The system requires a Dongle to run, so make sure the Dongle works well before powering on. In addition,
when using the system, it is required to connect to an IO interface board, so check whether the IO interface board
is properly connected before use. The system has only some Demo functions if no interface board is connected.
The system enters the welcome screen once it is started, as shown in Figure 3.1.1:
Figure 3.1.1 Welcome screen
Press any key under Welcome screen or wait for 5 seconds to enter main interface of the system：