Installation Guide

ManualsBrandsADT ManualsElectronicsMotion Sensor

is a PIR Motion (Passive Infrared) sensor, which can detect levels of infrared radiation from human body in its range of

view. It supports pet immunity, which is used to ignore the motion caused by animals and thus reduce the likelihood of false

alarms. The sensitivity of the sensor will disregard the motion caused by animals under 85 pounds, like a full-grown dog or small

cats.

These outstanding features of the sensor provides the professional security for protecting any home or business to save time,

money and deliver a great surveillance experience as well.

Specification

Frequency 1.9 GHz

Battery Type CR123A * 1

RF Transmission Range Outdoor: 100 Meters

Operating Temperature

0 C to 55 C (32° - 131°F)

Storage Temperature

10 C to 60 C (50° - 140°F)

Battery Life 5 Years (Assume 40 events per day @25°C)

Dimensions (H xW x D) 102 mm x 60 mm x 34.5 mm

Detect Range Distance: Max. 10M (±1M) w/mounting height 1.8M @25°C

Angle: Max. 90 (±10) Degree

Package Contents

Intallation

1. Installation and wiring methods shall be in accordance with National Electrical Code, ANSI/NFPA 70.

2. Detach the mount bracket from the device.

3. Install the provided batteries correctly.

4. Attach the mount bracket back to the device.

SSM5R0-29 Motion Sensor Installation GuideSSM5R0-29 Motion Sensor Installation GuideSSM5R0-29 Motion Sensor Installation GuideSSM5R0-29 Motion Sensor Installation Guide

SSM5R0-29

Summary of content (5 pages)

PAGE 1
SSM5R0-29 Motion Sensor Installation Guide SSM5R0-29 is a PIR Motion (Passive Infrared) sensor, which can detect levels of infrared radiation from human body in its range of view. It supports pet immunity, which is used to ignore the motion caused by animals and thus reduce the likelihood of false alarms. The sensitivity of the sensor will disregard the motion caused by animals under 85 pounds, like a full-grown dog or small cats.
PAGE 2
Operation 1. LED 4. Battery Cover (Wall Mount Bracket) 2. Tamper button 3. Battery  When the battery is installed, the Blue LED will be blinking for 90 seconds which indicates paring process is on going.  If pairing succces, Blue LED will be solid on for 3 seconds.If paring fail, Red LED will be solid on for 3 seconds.  If paring fail, press paring button for 5 second to restart paring process.
PAGE 3
Before selecting a position, the following installation hints should be noted: 1. Do not position the Motion Detector facing a window or direct sunlight. The device is also not suitable for using in draughty area where air conditioner or fan been installed. The excessive wind may cause false alarm. 2. Avoid aiming directly near heat sources, eg: fires, radiators, boiler etc. 3.
PAGE 4
Wall Mounting Note: The device is suggested to be set at 90 degrees angle, which is the best mounted position for offering the 10M protection area. 1. 2. Detach the mount bracket from the device. Mount the bracket with the supplied screws/tapes into the wall. It can be either mounted on a flat surface or in a corner. Note: Make sure the mount bracket is installed in the correct direction (upwards arrow). 3. Attach the device to the mount bracket.
PAGE 5
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.