Installation Guide

5
 Test Mode On/Off

Low Battery
1. Pairing

Install the RF battery and the Join/Leave Green LED will start blinking at 1 Hz for 90 seconds which indicates SD-
SMK03N is ready to join a DECT ULE network.

The device will attempt to joing a DECT ULE network for 90 seconds. If all attempts fail, SSS1R0-29 will stop
joininig process, and need to press and hold tamper for 5 seconds, and then release it to start joinging process.
2. Reset Device
 Press and hold the tamper while install the battery.
 Release the tamper after 10 seconds and DECT ULE module will be reset to factory default.
Note: SSS1R0-29 is used as a single station alarm. The RF is a supplement function to send events message to cloud
service via a DECT ULE gateway. If the network is down or RF signal interrupted, Smoke Alarm, Test Mode and Low
Battery funcitons are still operated locally via audible alert.