Installation Guide

Introduction

Installation/Replacement Battery

 Open the battery cover of the device.

 Install the supplied battery correctly.

 Close the battery cover.



Green LED starts blinking when it is ready to join DECT ULE network.



Please use a CR123A 3V battery. Use of a different battery may cause a detrimental effect on alarm operation.

Caution:

To ensure the product life and quality is as expected, please replace the whole device after it is triggered by a fire event.

Risk of Explosion if battery is replaced by an incorrect type. Dispose od used batteries according to this instruction.

Silence

1. If the device is alarming, press the “

Test /Silence

” button will have it silenced. If the smoke still remains after 10 minutes,

the device will alarm again.

Locations to install your SD-SMK03N

Smoke alarms should be installed in accordance with the NFPA Standard 72 (National Fire Protection Association, Battery march

Park, Quincy, MA 02169). For complete coverage, smoke alarms should be installed in all rooms, halls, storage areas, basements,

and attics in each family. For your information, the National Fire Alarm Code, NFPA 72, reads as follows:



Install in all guest rooms



Install outside of each separate dwelling unit sleeping area, within 6.4m (21ft) of any door to a sleeping room, the distance

measured along a path of travel.

 Install on every level of a dwelling unit, including basements.



Install on every level of a residential board and care occupancy (small facility), including basements and excluding crawl

spaces and unfinished attics.

 Install in the living area of a guest suite.

 Install in the living area of residential board and care occupancy.

 Install in ambient temperature between 4.4



C to 37.8



C (40° - 100°F).