Setup Guide

FCC ID: P27SCD2R0
8
If your existing doorbell produces an electronic sound that is programmable
and comes in the form of a unique sound, it's a digital chime. If it has a
traditional "ding dong" sound, it's a compatible analog chime.
4. Complete the pairing process and unplug the Micro USB cable from the
Doorbell Camera.
5. Identify the location for Mounting the Doorbell Camera
The recommended installation height of the Doorbell Camera is about 130~150cm from
the ground. Please refer to Chapter 3 Hardware Installation
for more details.
Chapter 3
Hardware Installation
This chapter covers the most likely problems and their solutions.
Overview
Note: Ensure the camera is configured and enrolled in AP or router before permanently
mounting.
Note: If SCD2R0-29 is using for engineering develop purpose, it is available to use Mirco USB
cable to charge the battery for replacing the transformer. And doorbell does not require
attaching with the chimer.
1. Check the voltage at the chimer to ensure voltage is between 8 ~ 24V AC.
2. Turn off the breaker circuit before disconnecting legacy doorbell button.
3. Unscrew the legacy doorbell to locate two power wires. (The recommended installation
height is between 47 -60 inches.)