Installation guide

ADT Pulse
®
Interactive Solutions iCamera-1000-ADT Indoor Low-Light Camera
Installation Guide
4
Rear Panel
Figure 2: Rear Panel
1. LAN Port
Use in conjunction with the supplied LAN cable to
connect your iCamera to the ADT Pulse Gateway.
2. Stand Mount
The stand mount connects the stand to the iCamera.
3. Reset Button
The reset button has two (2) functions:
Reboot. When the reset button is quickly pressed
then released, the iCamera reboots.
Clear All Data. To Clear All Data and restore the
factory default settings:
1. Power On.
2. Press and hold the Reset Button for eight
seconds.
When you release the Reset button, the iCamera is
reset to the factory default settings.
IMPORTANT
THE RESET BUTTON WILL RESET THE iCAMERA
COMMUNICATION CONFIGURATION SETTINGS AND
SHOULD ONLY BE USED UNDER THE DIRECTION OF
ADT SUPPORT.
NOTE
The default Wireless settings are:
Mode: Infrastructure
SSID: ANY
Wireless Security: Disabled
Domain: USA
Channel No.: Auto