Specifications

Section 3 – Web Configuration
D-Link DSL-2544N User Manual 53
RIP
Choose ADVANCED > Routing and click RIP. The page shown in
the figure
appears on the right. This page is used to select the interfaces on your device that
use RIP and the version of the protocol used.
If you are using this device as a RIP-enabled device to communicate with others
using the routing information protocol, enable RIP and click Apply to save the
settings.
RIPng
Choose ADVANCED > Routing and click RIPng. The page shown in the figure
appears on the right
. You can enable or disable dynamic routing of an IPv6
interface after establishing an IPv6 PVC connection.
NAT
Traditional NAT would allow hosts within a private network to transparently access
hosts in the external network, in most cases. In a traditional NAT, sessions are
uni-directional, outbound from the private network. Sessions in the opposite
direction may be allowed on an exceptional basis using static address maps for
pre-selected hosts.
Choose ADVANCED >NAT. The page is shown as the figure appears on the right.