Specifications

Section 3 – Web Configuration
D-Link DSL-2544N User Manual 49
UPnP
Choose ADVANCED > Network Tools and click UPnP. The page shown in the
figure appears on the right.
In this page, you can configure universal plug and play (UPnP). The system acts
as a daemon after you enable UPnP.
UPnP is used for popular audio visual software. It allows automatic discovery of
your device in the network. If you are concerned about UPnP security, you can
disable it. Block ICMP ping should be enabled so that the device does not respond
to malicious Internet requests.
Click Apply to save the settings.
ADSL
Choose ADVANCED > Network Tools and click ADSL. The page shown in the
figure appears on the right.
In this page, you can select a DSL mode. Normally, you can keep this factory
default setting. The device negotiates the modulation mode with DSLAM.
Click Apply to save the settings.
SNMP
Choose ADVANCED > Network Tools and click SNMP. The page shown in the
figure appears on the right. In this page, you can set SNMP parameters.
Click Apply to save the settings.