Specifications

Section 3 – Web Configuration
D-Link DSL-2544N User Manual 41
Note: The settings only apply when the firewall is enabled.
IP v6 Filtering
The configuration on IP v6 Filtering is similar to that on IP v4 Filtering. For the parameters description, please refer to IP v4 Filtering.
QoS
Choose ADVANCED > QoS. The QoS Configuration page shown in the figure
appears on the right.
The following table describes the parameters of this page.
Field Description
QOS Choose the box to enable the QOS.
Direction
Choose Upstream queue or Downstream queue.
Queue Enable Tick in the box to enable queue.
Bandwidth Total bandwidth for upstream flow
Discipline
Discipline type of QOS
WRR weight
When Discipline was chosen to WRR, you can
config WRR
Enable DSCP
Mark
You may tick in the box to permit DSCP Mark.
Enable 802.1P
Mark
You may tick in the box to permit 802.1P Mark.
After setting the parameters, click Save to save the QOS configuration.
In this page, click Add Rule. The page shown in the figure appears on the right.
You can configure QoS queue rule.