Specifications

Section 3 – Web Configuration
D-Link DSL-2544N User Manual 32
Security Settings
In the Wireless Settings page, click Security Settings. The page is shown as
the figure appears on the right. This page allows you to select a security mode.
Note that depending on the network authentication that is selected, the page will
change accordingly so additional fields can be configured for the specific security
mode.
Select SSID: Select the SSID that you want to configure from the drop-down list.
For the description of Work Mode field, please refer to the description of Wireless
Security Mode in 2.4G Wireless.
WPS Settings
In the Wireless Settings page, click WPS Settings. The page shown as the
figure appears on the right. In this page, you can configure Wi-Fi Protected Setup
(WPS).
Note: Before you configure WPS, please make sure you have configured the
Authentication Type to WPA, WPA2 or WPA/WPA2.
The following describes the parameters in this page.
Field Description
Wireless SSID Name of wireless network
WPA Mode
Set the security type of wireless network.
Enable WPS To enable or disable WPS.
Push Button Push the PBC button to begin communication.
Input PIN Number
Enter the station PIN from the wireless client, and
then click the PIN
button to establish the
connection.
WPS Session Status The status of WPS connection.
If you are using the PIN method, you will need a Registrar (access point/wireless
router) to initiate the registration between a new device and an active access