Specifications

Section 2 – Installation
D-Link DSL-2544N User Manual
11
LED
Color
Status
Description
Blinking WPS is successfully triggered.
Off Device is ready for new WPS setup.
Button and Interfaces
Figure 2 Rear panel
The following table describes the interfaces of the device.
Interface/Button
Description
ON/OFF Power switch, which is used to power on or power off the device.
POWER Interface for connecting the power adapter.
USB USB port for connecting a USB storage device.
LAN4/3/2/1
RJ-45 interface for connecting the device to the Ethernet interface of PC or other Ethernet devices through
the Ethernet cable.
DSL
RJ-11 interface for connecting the device to the telephone jack on the wall or the MODEM interf
ace of the
splitter through a telephone line.
WPS (on the side panel)
 Press and hold the button for 5 seconds to start 2.4GHz WPS negotiation. Press and hold for 5 to 10
seconds to start 5GHz WPS negotiation.
 Press and hold the button for 15 seconds to restore the factory defaults.
Best Location for Wireless Operation
Many environmental factors may affect the effective wireless function of the DSL Router. If this is the first time that you set up a wireless network
device, read the following information:
The access point can be placed on a shelf or desktop, ideally you should be able to see the LED indicators in the front, as you may need to view them