Specifications

Figure 1
EnerGenius Specifications
Electrical Performance
Input
Selection: Dual input range switch select
Nominal: 120/208-240 VAC
Full output: 60 Hz: 94-132 VAC, 57-63 Hz
187-264 VAC
50/60 Hz: 94-132 VAC, 47-63 HZ
187-264 VAC
Extended low line: 85/170 VAC
Output
Nominal voltage: 12-volt
24-volt
12/24-volt field programmable
(optional)
Battery 6 or 12-cell lead-acid;
compatibility: flooded or VRLA.
9, 10, 18, 19, 20-cell
nickel cadmium.
Voltage 6 discrete programs.
adjustment:
Voltage regulation: +
0.5% line and load
Current limit: 10 amps, rectangular characteristic
Charge mode 4-rate automatic
control: ·Constant current
·High-rate taper charge
·Finishing charge
·Maintaining charge
Fast-charge program (boost)
can be enabled or disabled in the field.
Dead battery Charger will recharge a fully
charge: discharged battery from zero volts.
Operation without BatterySENS system shuts down
battery: charger and issues alarm if the battery
is disconnected.
Status Indicators & Alarms
The EnerGenius alarm system exceeds NFPA-110
requirements, and it is the most comprehensive alarm
system available.
Charger/battery status and alarms
Local and remote indications by LED and individual
Form C contacts for each alarm. Form C contacts can
be field wired to provide a single summary alarm.
Output volts & Bright LED digital meter
amps: accurate to within +2% volts &
+5% amps
AC on: Green LED
Float mode: Green LED
Fast charge: Amber LED
TC active: Green LED
AC fail: Red LED and Form C contact
Low battery: Red LED and Form C contact
High battery: Red LED and Form C contact
Charger fail: Red LED and Form C contact
Battery fault: Red LED and Form C contact
indicating:
·Battery disconnected or reversed
·Mismatched battery, charger
voltage
·Charger to battery connections
damaged, loose or high resistance
·Battery internal resistance
excessive
Compensation slope with upper and lower limits, per
manufacturer recommendations.
Features
Temperature Enable or disable in the field.
compensation: Remote sensor is optional.
(see Figure 1)
Protection: Electronic current limit/short circuit
protection.
Soft start current walk-in.
Input and output fuses.
Reverse, wrong, Charger inhibit and fault alarm.
or no battery:
Overtemperature: Output current gradually reduces to
protect charger.
Circuit card: Surface Mount Technology (SMT),
conformal coated to resist
environmental attack.