Instruction Manual

VMT6008 10
©ads‐tecGmbH•Raiffeisenstr.14•70771Leinfelden‐Echterdingen
4 Commissioning
Thepowersupplyconnectionandinterfacesofthisdeviceareinstalledunderneathaprotectivecover.Thiscover
hastoberemovedinordertoconnectthepowersupplyleadandtheinterfacecables.
Allsupplyleadsandallrequireddataleadshavetobeconnectedbeforecommissioning.Allsupplyleadsandall
requireddataleadshavetobecon
nectedbeforecommissioning.
 Warning:
Thedevicemustbeswitchedoffbeforeconnectingordisconnectinganycablesinorderto
preventdamagetotheelectronics!
Thedevicemayonlybeswitchedonafteracclimatisingtotheambienttemperaturein
ordertoavoidcondensateaccumulation.Mak
esuretomeetthepermissiblevoltage
requirementsforthisdevice.
Afterswitchingoffandbeforeswitchingonyoumustwaitforatleast5seconds.
 Note:
Thescreenofadatacablemustalwaysbeconnectedwiththeconnectorhousing(EMC).
Undertheembeddedoperatingsystem,interfacesmustexplicitlybeenabledand
requireddriversmustbeinstalledinordertobeabletousethem.
4.1 AvailableInterfaces

Abb.2:
