Manual
Industrial PCs OPC7008
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
17
4 COMMISSIONING
Warning:
The PC must be switched off before connecting or disconnecting any cables in order to
prevent damage to the electronics!
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation.
Make sure to meet the permissible voltage requirements for this device.
After switching off and before switching on you must wait for at least 5 seconds.
4.1 AVAILABLE INTERFACES
The devices have the following interfaces by default:
Note:
The screen of a data cable must always be connected with the connector housing (EMC).
Under the embedded operating system, interfaces must explicitly be enabled and required
drivers must be installed in order to be able to use them.
Pos: 19 /Datentechnik/Inbetriebnahme/Kabelmontage/Kabelmontage für OPC7000-Serie @ 2\mod_1271079309582_6.doc @ 7602 @
4.2 CABLE INSTALLATION
The interfaces as well as power supply plugs for the device are accommodated in the
device service slot.
Pos: 20 /Datentechnik/Inbetriebnahme/Reihenfolge der Inbetriebnahme/Reihenfolge der Inbetriebnahme f ür OPC7000-Serie @ 2\mod_1271079348034_6.doc @ 7606 @