Instruction Manual

ADS XiLog+ System User Manual

C H A P T E R 2

Deploying the XiLog+

Deploying an ADS XiLog+ logger typically involves the involves the

following steps:

1. Programming the XiLog+

2. Performing a Signal Strength Test

3. Installing the XiLog+ at the Location

Deploy XiLog+ data loggers in a similar manner to other comparable units.

However, consider the following factors concerning GSM capabilities and

requirements during deployment:

• Mount the logger in an upright position, not at an angle or on its side.

• When installing the logger underground, mount the logger as close as

possible to ground level, preferably within 6 inches of the surface.

Following these guidelines will help ensure the GSM functions most

effectively. This chapter provides detailed instructions for each step in the

deployment process.