Owner's manual

ADS Environmental Services ADS Spider User Manual
Page 67
Text Message Commands
The Spider can receive and respond to specially coded text message
commands. The commands may:
1. Get the current state of all status signals
2. Get the current state of all controls
3. Reset an active alarm
4. Reset all active alarms
5. Activate and deactivate controls - can be protected with a 4-digit
PIN
6. Request Daily Report containing all of current day’s data (if e-mail
option installed)
7. Instruct the Spider to come online for a designated number of
minutes to allow Web access (when using AT&T static IP address
services)
The following text message commands are recognized:
Command Comment Example
HELP Request list of supported
commands
HELP
GET ST Get current state of all status
signals
GET ST
GET SYS Get current state of system
monitors
GET SYS
GET CN Get current state of all
controls
GET CN
RST ALx Reset Alarm x (x is 1 – 8) RST AL6
RST ALL Reset all active alarms RST ALL
ON CNx Activate control x (x is 1 – 8)
(no PIN)
ON CN2
yyyy ON CNx Activate control x (x is 1 – 8)
(PIN =yyyy)
1234 ON CN2
OFF CNx Deactivate control x (x is 1 –
8) (no PIN)
OFF CN4
yyyy OFF CNx Deactivate control x (x is 1 –
8) (PIN =yyyy)
1234 OFF CN4
PULSE CNx Pulse control x for 1 second PULSE CN4