User Manual

Sensor Installation and Connection 3-11
facing the outside of the ring. The side with the backstop
should face the inside of the ring.
Sliding t he ul trasonic sensor mount onto t he ri ng
6. Move the ultrasonic sensor mount around the ring.
Note: Steps 7 and 8 apply only to overlapping rings.
Proceed directly to step 9 for non-overlapping rings.
7. Slide the open end of the ring through the slot in the welded
band of the ring until it overlaps about 4 inches.
8. Spread the ring sections apart so that you can slide the ring
stabilizer with the spreader mechanism screw into the gap.