Owner manual

Introduction 1-5
Installation and Configuration
Following is the general procedure for installing and configuring a
FlowShark monitor. Refer to Chapters 3 through 7 for more details.
Chapters 8 and 9 contain additional installation instructions for
FlowShark monitors supporting analog inputs and/or outputs or
Modbus communications.
 Investigate Site Characteristics
• Flow Hydraulics
• Pipe and Manhole Characteristics
 Install the Sensors in the Pipe
• Assemble Ring (when applicable)
• Mount Sensors to Ring or Special Bands
• Secure Sensor Cables to Ring or Special Bands
• Install Ring or Band in Pipe
• Secure Sensor Cables Along Pipe and Up Manhole
 Connect Sensors to Monitor
 Attach Dryer Tube to Monitor
 Establish Telephone, Wireless, or On-Site
Communication with Monitor
 Configure Monitor (using Profile
®
Software)
• Create Monitor Location
• Create Installation Table
• Select and Edit Devices
 Set Communication Parameters (Profile)
 Activate Monitor (Profile)
 Run Diagnostics and Perform Confirmations (Profile)
 Install Monitor in Manhole