User Manual

10-4 ADS TRITON+ Manual
 Make sure all connector po r ts on the monito r to p ar e d r y. Use
compressed air or paper towels to dry out wet or damp
connectors. Note and replace missing interfacial seals in the
sensor connector ends. As a temporary measure, the
connectors can be protected against moisture by wrapping with
self-vulcanizing rubber stretch tape. M ake sure covers are
securely in place on any unused ports on the monitor top.
Confirming the Monitor
Confirm the accuracy of the sensor subsystems in the monitor on a
regular basis through Qstart. Confirmation involves comparing
manually-measured d e pth of flow and velocity readings to the
monitor's readings. This process also verifies sensor parameters.
Refer to the Qstart onli ne help for detailed information on
performing confirmation procedures.
Obtaining Diagnostic Codes from the Monitor
The TRITON+ enables you to observe monitor activity, view
diagnostic information, and confirm test cryouts from the monitor
thro ugh a small LED status window on the monitor top . The
numbers/characters displayed represent specific codes indicating
current processes, identification, status, o r r ead ings associated with
the system and communications. The following sections contain
general descrip tions and interpretations of the diagnostic
information avai lable t hrough the LED and instructions for
accessing information or prompting a message.