User Manual

Modbus 9-5
ExPAC
RS-485 CABLE
Positive Wire
Ground Wire
Negative Wire
Running the wires to t he proper t erminals on t he RS-485 terminal
connector
8. Insert the connector back into the RS-485 port on the ExPAC.
Note: Refer to the manufacturer’s documentation for the
device to which you a re connecting the ExPAC to
determine the appro p r iate pin-out for the RS-485
connector on the device end of the cable. Identify the pins
for the D+ and D- signa l s and the GND or SHL.
9. (applicable only when the ExPAC is housed within an XBUS or
other enclosure) Gently pull on the cable from the outside of
the enclosure to r emove any excess cabling inside the
enclosure. Hand-tighten the plastic nut on the cable gland
(when applicable) to secure the cable and prevent moisture or
debris from entering the inside of the enclosure through the