User Manual

6-82 ADS TRITON+ Manual
Collecting Data from the Monitor
Note: TRITON+ monit ors using SIMs with dynamic IP
addresses are capable of direct-serial or one-way, wireless
communication. Enable data collects for these monitors by
configuring and using the FTP Operations device. For
more information see Editing the FTP Operations Device,
page 6-61.
Collect data fro m a monitor in the following way:
1. Select the monitor from which you wa nt to c ollect data from
the Location Name drop-down list in the Monitor section on
the ADS Qstart dialog.
2. Click on the Collect butto n in the Functions section.
The Collect Span dialog displays for designating the date/time
range for which you want to collect the data.
3. Designate the date and time fro m which you want to begin
collecting data from the monitor in the Start field. Qstart
defaults to a start date and time of one second past the last data
point stored in the loc a l directory or network for the cur rent
location. To edit a particular value in the Start date or time
field, select the value and enter a new value or use the up/down
arr ows to advance thr ough the numbers until you re ach the
desired value.
4. Designate the date and time up to which you want to c ollect
data from the monitor in the End field. The end date and time
in Qstart default to the date and time on the local computer .
To edit a particular value in the cor r espo nding date or time,
select the value and enter a new value or use the up/down
arr ows to advance thr ough the numbers until you re ach the
desired value.
5. Click on the OK button.