User Manual

Configura tion and Activation 6-45
Edit the following parameters corresponding to the downward-
looking ultra s onic (s mart) depth sensor as necessary:
Note: Edit the parameters for an Ultrasonic Depth Sensor
equipped with the pressure option through the S urface
Combo Sensor device. Refer to Editing the Surface
Combo Sensor Device on page 6-28 for more information.
Parameters
Note: Under normal conditions, the pa r a meters in this
section (Parameters) should not require modification.
However, if additional adjustments are necessary, refer to
the detailed description of each parameter.
 Electronic Offset Enter the difference that exists between
the smart depth sensor readings and the manually measured
depth, when applicable. The default value is 0.
Note: An electronic offset is rarely needed. An offset
greater than +/- 0.5 inches (13 mm) typically indicates that
the physical offset or pipe height has been measured or
recorded incorrectly.
 Mode Select the mode in which yo u want the smart depth
sensor to operate based on environmental factors or site
constraints. ADS recommends using the Normal setting for
pipe heights ranging from 6 to 24 inches (15 to 61 cm) and
High for pip e heights gr eater than 24 i nches (61 cm) under
most conditions. However, if erratic Smart Depth readings
occ ur, co ns ider changing the Power setting.