User Manual

Introduction 1-13

Note: This is an excerpt from an agency-controlled

document for il l us tration purposes only. Changes to the

base controlled document require agency approval. For a

full-size copy of this drawing, please contact ADS and

request drawing number 8000BK0009-CERT.

Note: The Telog Ru-33 can be connected to the COMM

+ EXT PWR port on the TRITON+ monitor using the

Telog-Triton Comm Cable (ADS p/n 8000-0054-01).

However , this configuration has not been i ncluded on this

drawing because the Telog unit is not certified for IS

operation. Therefore, an installation involving this

configuration will not be considered intrinsically safe,

unless the Ru-33 is installed outside the hazardous area.

Cellular Modem Information a nd Compliance

Wireless telemetry is provided via a third-party, FCC - and carrier-

approved, commercial HSPA+/GSM or CDMA/EV-DO modem

inside the TRITON+ monit or and a corresponding antenna. Two

antenna opti ons are available thr ough ADS. However, customers

may o btain their own antennas to accommodate specific needs or

requirements. If a customer -supplied antenna is preferable or

required, consult an ADS or IETG, as applicable, representative

prior to installing the antenna to ensure it will adequately support

TRITON+ monitor communications and compliance.

European ATEX Hazardous Area Compliance

The following instructions apply to equipment covered by the

certificate numbered Sira 09ATEX2027X (TRITON+, U SB Serial

Interface, and Combo Sensors CSX Series). Reference European

ATEX Directive 94/9/EC, Annex II, 1.0. 6:

 The equipment may be used with flammable gases and vapors

with apparatus groups IIA and IIB and with temperature classes

T3 (152

C), T4, T5, and T6.