Operation Manual

GB
Water and waste water
12
68 Adria Vans
12.1.1 Water tank
Filling the water tank (external):
 Switch the water pump off on the control panel (Chapter 8.7).
 Close the drain on the tank bottom.
– Some models are fitted with a water regulation system (special equipment)
(Fig. 46/2). An adjusting grip (Fig. 46/3) (Fig. 45/5) is positioned on the top side of the
tank to regulate and drain the water.
– Turn the grip clockwise to close the system and have all the water available for use.
 Unlock and open the lockable cap (Fig. 45/3) on the filler neck (Fig. 45/2).
 Fill water with a water canister, a watering can or a hose into the water tank.
 Replace, close and lock the cap.
Draining/cleaning the water tank:
 Switch the water pump off on the control panel (Chapter 8.7).
 Open the drain plug on the tank bottom. To do this, depending on the system:
– Either open the service cover (Fig. 45/4), fold the grip on the plug in the tank
(Fig. 46/1) down and pull the plug out,
– or turn the adjusting grip of the regulation system (Fig. 46/3) or (Fig. 45/5) anticlock-
wise to the stop.
 Drain the water tank completely.
 Clean the inside of the tank.
 Close the plug in the tank bottom, and the service cover when necessary.
Fig. 45 Filling the water tank - external
1 Water tank
2 Filler neck
3 Lockable cap
4 Service cover
5 Water regulation adjusting grip
(special equipment, position
depends on equipment)
Fig. 46 Emptying the water tank - systems
1 Quick release fastener
2 Water regulation system
3 Adjusting grip
10100070
1
4 5
2 3
10100069
1
3
2