Operation Manual

GB
Living
8
52 Adria Motorhomes
Alarms:
The alarms call attention to various problems:
• The voltage of the starter battery (B1) is lower than 11.8 Volt or the voltage of the living area
battery (B2) is lower than 10 Volt. The following alarm signals occur in both cases:
- a signal tone,
- an alarm display and
- the corresponding LED blinks.
• Water tank (S1) is empty or waste water tank (R1) is full. The following alarm signals occur
in both cases:
- a signal tone,
- an alarm display and
- the corresponding LED blinks.
Switching the alarm off:
 Touch the light pressure sensor with the alarm display longer than three seconds.
Display "Malfunction":
Display "Malfunction" (Fig. 35/2) goes on when a fault occurs.
An error code is shown on the display (Fig. 35/11):
• E.1: The serial cable is not connected properly.
• E.2: Output "Pump" is short-circuited or overloaded.
• E.6: Output "Exterior lighting" is short-circuited or overloaded.
• E.7: Output "AUX"/output "Boiler" is short-circuited or overloaded.
• E.3, E.4, E.5: Fault in a relay switch, incorrect connection to power supply.
For more information, see the separate instructions from the manufacturer.