Operation Manual

GB
Living
8
Adria Motorhomes 51
Sensor "Exterior lighting“:
 Touch sensor "Exterior lighting“ (Fig. 35/13) to switch the exterior lighting on or off.
Sensor "AUX":
 Touch sensor "AUX“ (Fig. 35/4) to switch AUX on or off.
Sensor "Pump":
 Touch sensor "Pump“ (Fig. 35/12) to switch the pump on or off.
Sensor "Starter battery B1":
 Touch sensor "Starter battery B1" (Fig. 35/5) once to show the voltage of the starter bat-
tery (B1) on the display (Fig. 35/11).
 Touch sensor "Starter battery B1" twice to show the remaining battery capacity as a per-
centage on the display.
Sensor "Service battery B2":
 Touch sensor "Service battery B2" (Fig. 35/6) once to show the voltage of the service
battery (B2) on the display (Fig. 35/11).
 Touch sensor "Service battery B2" twice to show the remaining battery capacity as a
percentage on the display.
Sensor "Charge/discharge service battery":
 Touch sensor "Charge/discharge service battery" (Fig. 35/7).
If the battery is being charged, "+A" is shown on the display (Fig. 35/11). If the battery
is being discharged, "-A" is shown on the display.
Sensor "Fresh water tank":
 Touch sensor "Fresh water tank" (Fig. 35/10) to show the level of the fresh water tank
(S1) as a percentage on the display (Fig. 35/11) (0 %, 25 %, 50 %, 75 %, 100 %).
When the fresh water tank is empty, the indicator blinks on the display (Fig. 35/11). If
the tank connection is faulty, " - - -" is shown on the display.
Sensor "Waste water tank":
 Touch sensor "Waste water tank" (Fig. 35/9) to show the level of the waste water tank
(R1) as a percentage on the display (Fig. 35/11) (0 %, 25 %, 50 %, 75 %, 100 %).
When the waste water tank is full, the indicator blinks on the display (Fig. 35/11). If the
tank connection is faulty, " - - -" is shown on the display.
Sensor "Temperature display":
 Touch sensor "Temperature display" (Fig. 35/8) once to show the interior temperature
on the display (Fig. 35/11).
 Touch sensor "Temperature display" (Fig. 35/8) twice to show the exterior temperature
on the display (Fig. 35/11).
If the temperature sensor is missing, "0Pt" is shown on the display. If the temperature
sensor is defective, "-" is shown on the display.