Operation Manual

GB
Living
8
Adria Motorhomes 49
The scale legend "%" (right) lights or blinks and the fill level of the selected tank is shown
on the LED scale concerned (Fig. 34/3) or (Fig. 34/4).
The water tank is empty or the waste water tank full when the symbol of the selected tank blinks
while the fill level is indicated.
When the LEDs of the LED scale concerned blink, there is a sensor error on the respective
tank.
Switching the different 12 V appliances on and off
The voltage supply to the pumps and the tank heater can be individually switched on or off.
The 12 V supply voltage must be switched on in order to switch the different 12 V appliances
on and off.
Switching the pump on and off:
 Turn the rotary setting button (Fig. 34/10) until the water tank fill level is shown on the
LED scale (Fig. 34/4).
The pump is on when the "Pump" symbol (Fig. 34/2) lights.
 Press the rotary setting button (Fig. 34/10) to change the switched state.
The "Pump" symbol (Fig. 34/2) lights or goes off. The 12 V supply of the pump is
switched on or off.
Switching the tank heater on and off:
 Turn the rotary setting button (Fig. 34/10) until the waste water tank fill level is shown on
the LED scale (Fig. 34/3).
The tank heater is on when the red LED (Fig. 34/5) above the "Waste water tank" sym-
bol (Fig. 34/6) lights.
 Press the rotary setting button (Fig. 34/10) to change the switched state.
The red LED (Fig. 34/5) lights or switches off. The 12 V supply of the tank heater is
switched on or off.
For more information, see the separate instructions from the manufacturer.
Important!
The indicator goes off after approx. 20 s when no button is pressed in this time.
Important!
When the 12 V supply voltage is switched off, the "Pump" power supply is also switched off.
Important!
The switching state of the "Tank heater" is maintained when you switch the 12 V supply volt-
age off. The red LED goes off when the 12 V supply voltage is switched off, but the tank
heater remains switched on.