Operation Manual

GB
Heater & hot water
13
106 Adria Motorhomes
13.1.4 Winter operation
13.1.4.1 Heating with hot water preparation:
Boiler must be filled with water (Chapter 13.1.9).
 For vehicles with Truma Combi E, set the desired power type on power selector switch
(Fig. 80):
- gas operation (Fig. 80/3)
- electrical operation 1800 W (Fig. 80/1) or 900 W (Fig. 80/2)
- mixed operation 1800 W (Fig. 80/5) or 900 W (Fig. 80/4)
 Set the rotary switch to "60 °C heating" (Fig. 81/5).
 Turn the rotary knob (Fig. 81/1) on the control panel to the desired thermostat setting
(1-5) for room temperature.
After switching on, the green operation indicator lamp (Fig. 81/2) and the yellow water
heating lamp (Fig. 81/7) on the control panel go on.
The unit gradually reduces the power until the selected room temperature is reached. If
the room temperature has been reached but the water still has to be heated, the circu-
lation fan switches off and the water continues to be heated to a temperature of 60 °C
at the lowest power setting.
The yellow indicator lamp (Fig. 81/7) is on during heating and goes off when the water
temperature is reached (60 °C).
13.1.4.2 Heating without hot water preparation:
 For vehicles with Truma Combi E, set the desired power type on power selector switch
(Fig. 80):
- gas operation (Fig. 80/3)
- electrical operation 1800 W (Fig. 80/1) or 900 W (Fig. 80/2)
- mixed operation 1800 W (Fig. 80/5) or 900 W (Fig. 80/4)
 Set the rotary switch to "winter mode" (heating without hot water preparation) (Fig. 81/4).
 Turn the rotary knob (Fig. 81/1) to the desired thermostat setting (1 -5).
After the heater is switched on, the green "On" indicator lamp (Fig. 81/2) on the control
switch goes on.
When the selected room temperature has been reached, the heater switches off, inde-
pendent of the water temperature. If there is water in the boiler, it will also be heated in
this mode of heating.
Important!
The water can be heated to up to 60 °C depending on the heating power that is required to
achieve the room temperature.
Important!
• When the boiler is filled, the water is automatically heated.
• The water temperature is dependent on the specified heater performance and the dura-
tion of the heating for reaching the room temperature.