Operation Manual

GB
Heater & hot water
13
Adria Motorhomes 105
13.1.2.2 Truma CP plus control panel
Some vehicles are optionally equipped with control panel Truma CP plus.
The rotary push button (Fig. 82/8) serves to select menus or to change values to be set.
 Turn the rotary push button left or right to select a menu item or to change values.
 Press the rotary push button to activate the menu item or to save the value set.
 Press the rotary push button for more than 3 seconds to switch the control panel on or
off.
Use the Back button (Fig. 82/9) to return to the previous menu or the previous display.
The settings in the menus are performed analog to the settings described for Truma Combi
and Truma Combi E. For more information, see the separate instructions from the manufac-
turer.
13.1.3 Summer operation
Preparing hot water:
Boiler must be filled with water (Chapter 13.1.9).
 For vehicles with Truma Combi E: Set gas or electrical operation on the power selector
switch (Fig. 80/1,2,3).
 Set the rotary switch to summer operation (Fig. 81/3) 40 °C or 60 °C.
When the equipment is switched on, the green (Fig. 81/2) and yellow indicator lamps
(Fig. 81/7) go on.
When the set water temperature (40 °C/60 °C) is reached, the heater is switched off and
the yellow indicator lamp (Fig. 81/7) goes off.
Fig. 82 Control panel Truma CP plus (special equip-
ment)
1 Display
2Status bar
3 Menu bar (upper)
4 Menu bar (lower)
5 230 V mains supply indicator
(power)
6 Time switch display
7 Settings / values
8 Rotary push button
9 Back button
Important!
Gas or electrical operation is possible in summer mode. With the setting "Mixed operation",
the unit automatically selects electrical operation with the preselected electrical power of
900 W or 1800 W.
1
6
2
3
5
4
8
7
9