Operation Manual

Heater & hot water 13

Adria Caravans 103

The transformer (Fig. 80/1) for the electric floor heating is fitted in the seat chest or bed box

depending on the model.

Using the electrical floor heating:

 Check the circuit protection for the 230V power supply at the camping site is adequate.

(350 W - 1.5 A)

 Check the connection cable is wound off fully from the cable reel.

 Check the 230 V circuit breaker in the vehicle is switched on.

 Check the mains plug of the transformer is connected to a 230 V socket.

 Press the rocker switch (Fig. 81/2). The control lamp (Fig. 81/1) in the swich goes on.

Switching the electrical floor heating off:

 Press the rocker switch (Fig. 81/2). The control lamp in the switch (Fig. 81/1) goes off.

 The floor remains warm for some time after switching off due to residual heat.

The electrical floor heating has an overload protection. The overload protection triggers when

the transformer is overloaded. The pin (Fig. 80/2) springs out.

 When the transformer has cooled down, push the pin (Fig. 80/2) on the overload protec-

tion back in again.

For more information, see the separate instructions from the manufacturer.

Fig. 80 "Electrical floor heating" transformer

1 Transformer

2 Overload protection pin

Fig. 81 "Electrical floor heating" switch

1 Control lamp

2 Rocker switch

10100008

10100002