Operation Manual

DD
Gas system 11
Adria Motorhomes 85
Changing gas cylinders
 Close the shut-off valve (Fig. 59/1) of the empty gas cylinder.
 Unscrew the high-pressure hose with adapter piece (Fig. 59/2) from the gas cylinder or
remove the plug-on adapter, if required.
 Replace the empty gas cylinder in the gas cylinder compartment by a full gas cylinder.
 Secure the gas cylinders against falling over with an attachment strap (Fig. 59/3).
 Screw the high-pressure hose with adapter piece (Fig. 59/2) to the full gas cylinder or
insert the plug-on adapter.
 Open the shut-off valve of the full gas cylinder.
 Press the hose rupture protection and green gas flow monitor (Chapter 11.6.1).
11.6.3 SecuMotion/MonoControl CS - changing the high-pressure
hose
If damage is visible on the high-pressure hose, it must be replaced.
Use the screwing tool provided for screwing the high-pressure hose on and off.
The screwing tool ensures the required tightening torque and prevents damage to the screw
connection caused by the wrong tools.
Changing the high-pressure hose:
 Close the shut-off valve (Fig. 59/1) of the gas cylinder.
 Unscrew the high-pressure hose from the adapter piece of the gas cylinder (Fig. 59/2)
and from the regulator inlet or remove the plug-on adapters, if required.
 Screw a new high-pressure hose to the adapter piece of the gas cylinder (Fig. 59/2) and
the regulator inlet, attach the plug-on adapter.
 Open the valve of the gas cylinder.
 Press the hose rupture protection and green gas flow monitor (Chapter 11.6.1).
Fig. 59 Changing gas cylinders
1 Shut-off valve
2 High-pressure hose with adapter
piece
3 Attachment strap
Important!
Also replace the seal after every change of the high-pressure hose.
1
2
3