Operation Manual

DD
Living 8
Adria Motorhomes 49
"Batteries" button:
 Switch on the LED panel (Fig. 31/2).
 Press the "Batteries" button (Fig. 31/3) once to indicate the voltage of the living area bat-
tery.
The battery voltage of the living area battery is indicated by the left indicator (Fig. 31/7)
in the lower part of the scale (Fig. 31/9).
 Press the "Batteries" button (Fig. 31/3) again to indicate the current of the living area
battery.
The current of the living area battery is indicated by the left indicator (Fig. 31/7) in the
upper part of the scale (Fig. 31/10).
 Press the "Batteries" button (Fig. 31/3) again to indicate the voltage of the starter bat-
tery.
The battery voltage of the starter battery is indicated by the left indicator (Fig. 31/7) in
the lower part of the scale (Fig. 31/9).
"Pump" button:
 Switch on the LED panel (Fig. 31/2).
 Press the "Pump" button (Fig. 31/4) to switch the supply voltage for the water pump on
or off.
The switched state is saved after the LED panel is switched off.
"Tanks" button:
 Press the "Tanks" button (Fig. 31/5) to indicate the level of the water tank.
 Press the "Tanks" button (Fig. 31/5) again to indicate the level of the waste water tank.
The tank levels of the tanks are shown in % by the right indicator (Fig. 31/8).
Alarms:
The purpose of the alarms is to call attention to various problems:
• Battery requires charging
• Tank full or empty
• etc.
For more information, see the separate instructions from the manufacturer.
Important!
The indicator goes off after approx. 20 s when no button is pressed in this time.
Important!
The values are no longer measured after the engine has been started. The last tank level is
saved when the engine is started and indicated accordingly when queried.