User's Manual

Advanced RF Technologies, Inc.
15
output of one antenna does not reach the input of the other. This distance is dependent on the gain of the
repeater.
- Prior to equipment use the service must be registered with the FCC. This can be done through the FCC’s
website at https://signalboosters.fcc.gov/signal-boosters)
5. DEFAULT ITEMS
Items
Model name
Antenna
Cable
Coupling device
6. SPECIFICATION
Parameters
Specification
Remarks
DL UL
Frequency Range
(Nominal
Bandwidth)
(MHz)
VHF
FCC: 150~174 (24)
IC: 138~144 (6), 148~174 (26)
UHF
FCC: 406.1~470 (64.1), 470~512 (42)
IC: 406.1~430 (24.1), 450~470(20)
Composite Output
Power
VHF
28 dBm
24 dBm
UHF
37 dBm
27 dBm
Rated Mean
Output Power
VHF 28 dBm 24 dBm
Rated output power of this
equipment is for single carrier
operation. For situations when
multiple carrier signals are
present, the rating would have to
be reduced by 3.5 dB, especially
where the output signal is re-
radiated and can cause
interference to adjacent band
users. This power reduction is to
be by means of input power or
gain reduction and not by an
attenuator at the output of the
device.
UHF 37 dBm 27 dBm
Nominal Pass Band
Gain
(dB)
VHF
85
85
UHF
95(LMR450)
85(APCO25)
95(LMR450)
85(APCO25)
Filter selection
Wide or Narrow
Wide or Narrow
Support Filter
numbers
Wide
1
Narrow
Up to 8(Noncontiguous)
Filter Bandwidth
Wide(MHz) 1/2/4/5
Future update available by custom
filter
Narrow(kHz)
6.25 ~75 (6.25 x n , n= 1~12)
Noncontiguous
Filter Roll-off
Wide: 65dBc@Filter Bandwidth Edge + 500KHz Narrow:
60dBc@Filter Bandwidth Edge + (Filter BW / 2)
Spurious
FCC meet
Passband Ripple
±2 dB
Any 15MHz BW
ALC Dynamic Range
60dB
Gain Dynamic Range
45dB