User Manual

Advanced RF Technologies, Inc.
25
External Alarm Name
Set Condition
Donor Antenna Malfunction
- UL Return Power Hard Fail or No DL Signal Detected
Active RF Emitting Device Malfunction
- RF Power Soft Fail
- DL Return Power Hard Fail
- DL/UL Over Power Hard Fail
- DL/UL Input Overload Hard Fail
System Component Malfunction
- Over Current Hard Fail
- Over Temperature Hard Fail
- DSP Hard Fail
- Out-band Overload Hard Fail
3.3.2 External Alarm Input interface
User Alarm Input Port
No
External Alarm In
User Alarm
Remark
1
ALARM IN 1
TBD
4. INSTALLATION
4.1 Installation Procedures
4.1.1 Wall Mount Procedure
 Verify that the PSR-78-9537-XB and mounting holes are in good condition
 Place the PSR-78-9537-XB mounting bracket template up against the wall and mark off mounting holes
 Drill the appropriate size holes and install the included wall anchors
 Remove the wall mount bracket from the repeater and bolt the wall mount bracket to the wall
 Place the repeater onto the wall mount bracket and secure the bracket to the repeater
 Connect the GND cable
 Connect the Antenna cables
 Connect the Power cable
Figure 4-1 Wall Mount
Wall Mount
Bracket