User's Manual

Advanced RF Technologies, Inc. 19
The AC Power on/off switch and AC selection switch are located at left of PSU. The AXM700-9543 PSU can
operate at 110V AC and 220V AC. The user should verify that the AC input voltage selection switch is set to the
correct voltage before powering on the AXM700-9543.
2.2.4 Back Up Battery Port
Figure 2-5 Battery Backup Port
The AXM700-9543 can be connected to an ADRF-BBU (ADRF Battery Backup) to provide power during a power
failure. If an ADRF-BBU is utilized, connect the ADRF-BBU to the AXM700-9543 via the external battery port.
(WARNING: The circuit switch on the ADRF-BBU must be set to OFF before connecting the ADRF-BBU to the
AXM700-9543 to prevent damage to the repeater or the ADRF-BBU and personal injury.)
Note: Please contact ADRF Technical Support for assistance if you are unfamiliar with the installation
procedure of our battery box.
2.3 RF Ports
Figure 2-6 RFU RF port
2.3.1 RF Ports
• DONOR – DIN female which is used to connect the donor antenna
• DONOR_CPL (30dB) – SMA female 30 dB coupling port which is used to monitor the amplified UL signal
• MODEM_ANT – SMA female port which is used to provide RF signal to the optional internal modem box
• SERVER_CPL (30dB) – SMA female 30 dB coupling port which is used to monitor the amplified DL signal
• SERVER – DIN female which is used to connect the server antenna