User's Manual

Advanced RF Technologies, Inc. 16
2. OVERVIEW
2.1 LED
AXM700-9543 has LEDs in the upper left corner as shown below in figure below.
Figure 2-1 LED panel
Table 2-1 RF Module LED Specifications
LED Indicator Specifications
Power Solid Green System power is ON
Solid Yellow Soft Fail alarm exist in the system Soft Fail
OFF No Soft Fail alarm are present in the system
Solid Red Hard Fail alarm exist in the system Hard Fail
OFF No Hard Fail alarms are present in the system
Input < -85dBm Zero (0) bar On
Input < -75dBm One (1) bar On
Input < -65dBm Two (2) bars On
Input < -55dBm Three (3) bars On
Input < -45dBm Four (4) bars On
RSSI
Input >= -45dBm Five (5) bars On
2.2 Ethernet Port and Host/Remote Switch
Figure 2-2 Ethernet Port and Host/Remote Switch
2.2.1 Ethernet Ports
• Modem – The Modem port is to only be used when the optional internal modem box (Digi Transport-WR21) is
used with the repeater. This port directly connects to the Ethernet port of the internal modem box. If a Digi
Transport WR-21 is being used with the repeater, used the included RJ-45 jumper cable to connect the Local
and Modem ports together and then flip the Host/Remote switch to the Remote position.